Dutyhook 3D Printed Bow Tie, for 4-12 mm Symmetric Carbine Hooks, black plastic
0,21 €
Nettopris. Moms tillkommer vid utcheckningen.
3D printed Bow Tie for ordering with 4-12 mm Symmetric Carbine Hooks. Tie slides to the neck of carbine hook from wider side and keeps carbine on place. Meant for keeping Carbine Hook on closed fixing points (ring, u-bolt, eye-nut etc), where eyelet can not be used. Thin wall design for flexible installation. Not meant for loads, just keeps the hook installed. Choose Carbine Hook size before adding to basket. Can be ordered separately, but without Carbine Hook fit will not be granted. In case of separate order, order is fulfilled only when you provide carbine neck minimum width in remarks. If ordered with carbine then fit is tested and granted.
Printed on order, so please allow day or two for printing. Made of black PET-G (material commonly used for plastic bottles). May be used outdoors. Not meant for high temperatures or heavy load. Made by Dutyhook in Estonia.
Produktanpassning
Glöm inte att spara din anpassning innan du lägger produkten i kundvagnen
3dpr_bow_tie
Datablad
- Material
- PET-G
- Underkategori
- Symmetric Carbine
3D printed Bow Tie for ordering with 4-12 mm Symmetric Carbine Hooks. Tie slides to the neck of carbine hook from wider side and keeps carbine on place. Meant for keeping Carbine Hook on closed fixing points (ring, u-bolt, eye-nut etc), where eyelet can not be used. Thin wall design for flexible installation. Not meant for loads, just keeps the hook installed. Choose Carbine Hook size before adding to basket. Can be ordered separately, but without Carbine Hook fit will not be granted. In case of separate order, order is fulfilled only when you provide carbine neck minimum width in remarks. If ordered with carbine then fit is tested and granted.
Printed on order, so please allow day or two for printing. Made of black PET-G (material commonly used for plastic bottles). May be used outdoors. Not meant for high temperatures or heavy load. Made by Dutyhook in Estonia.
Kommentarer (0)
3D printed Bow Tie for ordering with 4-12 mm Symmetric Carbine Hooks. Tie slides to the neck of carbine hook from wider side and keeps carbine on place. Meant for keeping Carbine Hook on closed fixing points (ring, u-bolt, eye-nut etc), where eyelet can not be used. Thin wall design for flexible installation. Not meant for loads, just keeps the hook installed. Choose Carbine Hook size before adding to basket. Can be ordered separately, but without Carbine Hook fit will not be granted. In case of separate order, order is fulfilled only when you provide carbine neck minimum width in remarks. If ordered with carbine then fit is tested and granted.
Printed on order, so please allow day or two for printing. Made of black PET-G (material commonly used for plastic bottles). May be used outdoors. Not meant for high temperatures or heavy load. Made by Dutyhook in Estonia.